100 GPD replacement membrane for aquarium osmosis aquarium platinum more.

The action of the membrane is to remove harmful elements for aquarium water, such as heavy metals, certain bacteria, mineral salts and to let the H2O molecules pass.

Tips  for use :

During the first use of your osmosis as well as when replacing the membrane, it is  advisable to allow 30 to 40 liters  of water produced to eliminate the membrane preservation able  to use osmosis water .

The osmosisist works with water at room temperature. Neither too hot water should never be treated (more than 35 ° C) or too cold (less than 10 °  C  ) . A temperature beyond these limits  irreparably damage the membrane. Optimal  production  osmotic water is done at a temperature of 25 ° C.
The passage of water in the membrane implies a fairly high pressure greater than 2.5 bars) for the reverse osmosis to be  activated . The pressure being 4 to 4.5 bars. If the speed of your tap is too low , we  using a booster pump.

It is recommended to rinse the membrane every month , depending on the following procedure:
1. Disconnect the pressure
2. Let  the water run 20-25 minutes
3. Reconnect pressure reducer .

Important: the  indicated flow is reached  in optimal conditions . This  may  vary depending on the pressure out of your tap as well as the water to be treated .

Replacement of cartridges and membrane of the aquarium osmosis

We  advise you to replace coal cartridges and sediment every 3500-4000 liters  of running water treated or every 6 months .

The membrane should be changed each year, except in the event of prolonged non -use of the osmosis, the membrane dries up and must be changed immediately.

Recommendation: Never your membranne dry. Keep it in a wetland or in a storage solution in the event of an extended use of use

Always use your menbranne with an active coal pre-filter.